PE-10SN – 10 Amp, 6-Circuit with QuadraSync, 24VDC-asian-technologies-ltd

System Features
• Input voltage: 120/240VAC 50/60Hz
• Output voltage 24VDC @ 10A
• Six class “B” Style “Y” notification circuits on the PE-10SN
• Rated at 3 amps max each
• Can be configured as up to three class “A” Style “Z” notification circuits
• Supervised Battery Charger: 27.3 @ 1A (supports 7-55 Ahr batteries)
• Integrated battery cut-off circuitry to protect batteries from deep discharge
• Two Trouble Relays (5A at 30VDC)
• General System Trouble (programmable for AC delay via dip-switch)
• Low AC Trouble
• Diagnostic LED’s
• Status LED’s for Active NAC and NAC trouble conditions
• Status LED’s for Earth Fault (Amber), AC (Green), Battery Fault (Amber)
• Trouble Memory feature captures troubles which have previously restored.
• Synchronized notification appliance circuits
• Potter
• Wheelock®
• Gentex®
• System Sensor®
• Configurable output circuits (D.I.P. switch sets options for each circuit)
• ANSI temporal-coded
• Constant Power
• Door-Holder Power
• Separate DC Power Output (3A)
• Two Trigger Inputs (Class A, Style Z or Class B, Style Y)
• Reference EOL terminals, allows 2K – 27K EOL value to be used
• QuadraSync panel wide synchronization of same or multiple brands.
• PassThru mode copies input signals to output (can be used in conjunction with QuadraSync
Mounting Instructions
The standard mounting is a surface mount cabinet. The unit must be securely attached to a permanent partition using suitable
fasteners. Five mounting holes are provided to accept ¼ inch diameter screws maximum. There are seven knock outs provided.
Operating Instructions
Alarm Condition
Notification Appliance Circuit:
Alarm devices operate in unison with the Trigger inputs from the main Fire Alarm Control Panel (FACP). When activated by
the corresponding trigger input the associated Notification Appliance Circuit (NAC) will reverse polarity from a supervision state
to the alarm state and supply power to the associated notification appliances until the trigger is removed. Each activated NAC
will also power the L.E.D. associated with it, the L.E.D. will follow the steady or pulsing state of the NAC. The alarm-activated
outputs are reset through the operation of the reset function of the Main FACP.

Electrical Operating Characteristics

Input Voltage 120 VAC @ 5.1 Amps or 240 VAC @ 2.5 Amps (Jumper selected) 50/60 Hz
Input Trigger 8 VDC to 33 VDC (15 ma) filtered or full wave rectified. Polarity reversal or continuous
voltage
Output Voltage 24 VDC @ 10 Amps
Notification Outputs 24 VDC 3.0 Amps Maximum, Polarity Reversal
DC Power 3.0 Amps
Total System Current PE-10SN = 10 Amps
(total system load from all output circuits must not exceed 10 amps total